Input (Punching)

Last modified by Fredrik Lagerström on 2021/06/29 09:40

The Input menu option makes it possible to state all necessary input data to describe the current calculation problem. The user finds the options Title, Mode, Material, Geometry, Reinforcement details, Loads and Shear reinforcement. These are described in the following chapters.

Title

The Title option shows a dialog box where information on the calculation can be defined.

1621928844971-293.png

Mode

Punching calculation can be performed for rectangular and circular columns.

1621928865436-121.png

Material

In the material dialog box all material strength input is assembled.

1621928893975-759.png

General

Under the header General, conditions that affect the calculation are stated. Exposure class and life time class are defined and affect code checks where relevant. The options Quality control and reduced deviation and Reduced or measured geometrical data can be checked. The two latter options together with the option Low strength variation, see below, changes the partial factors for materials according to EN 1992-1-1 Annex A A2.1 and A2.2.

Concrete

Concrete strength class can be defined by selecting from the list. Current design values are shown. It is also possible to define user defied values. If the option Low strength variation is checked together with one or both of the two options described above the partial factor for concrete will be changed according to EN 1992-1-1 Annex A A2.1 and A2.2.

Reinforcement

In the Reinforcement dialog boxes type of reinforcement bars and links can be defined by selecting from lists.

Geometry

Column measurements, slab thickness and effective part of the critical perimeter are defined. The latter is to consider possible holes in the vicinity of the column.

1621928952229-699.png

Type of column, interior, edge or corner column is defined. For an edge column also a possible distance from slab edge to column edge in the x-direction could be defined. (Max distance is the slab thickness). For a corner column a possible distance from slab edge to column edge both in x- and y-direction could be defined.

Reinforcement details

Bar diameter, reinforcement amount in x- and y-direction and cover are defined. The reinforcement amount can then be defined either as c/c distance (mm) or as a percentage.

1621928983076-358.png

It is possible to inactivate the code rules concerning allowed covers.

Loads

Punching force, moment Mx around y- and My around x-axis are defined. Ten load combinations can be analyzed at the same time.

1621929533957-596.png